Zilog ZAURCT Manuel d'utilisateur télécharger pdf (Page 26)

UM022903-0311 ZAURA System Installation and Configuration

ZAURA

™

RF Wireless Lighting Control

Installation Guide

operation returns) or until a new press of the Set Mode button. This mode can be used

after the association of the ZAURA Virtual Dimming Starters to validate that the starters

associated properly.

PIR Test. This mode displays PIR detection status by turning on the blue LED whenever

occupancy is detected. The PIR Test will continue for the lesser of five minutes (after

which normal operation returns) or until a new press of the

Set Mode button.

After you are finished using one of the above special modes, it is good practice to return

the DIP switches to the Normal Operation position.

Dim Control Setting

The Dim Control DIP switches are used to determine how the system reacts to the amount

of natural light in the room, as shown in Figure 16.

Normal Operation. All Virtual Dimming luminaries are turned off if the natural light

level is greater than the dimming threshold, as set by the Light Sensitivity POT. If the nat-

Figure 15. Setting Special Mode DIP Switches

Note:

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 58 59

Pas de commentaire

Zilog ZAURCT Manuel d'utilisateur Page 26